The following are steps on how to record and access the 4K UHD Camera’s internal SD card's files.
Navigate to Menu --> Settings --> Data Logging
Ensure the 'Camera onboard recording' toggle is turned ON
3. Start a Data Log by pressing the right side button on the hand controller
A computer with a modern web browser (Chrome/Firefox)
Up-to-date firmware on the Controller (6.10 or above) and 4K UHD Camera (1.7 or above)
Ethernet cable
Ensure the PC’s network configuration is set up to receive a dynamic IP address over DHCP (This is the default on Windows PCs)
Before connecting the ethernet cable, turn ON the DHCP setting on the Controller. This is found in Settings --> Network
Connect an ethernet cable between the Controller and the PC
Before connecting the ethernet cable, turn OFF the DHCP setting on the Controller. This is found in Settings --> Network
Connect an ethernet cable between the Controller and a LAN port on the router
Connect a second ethernet cable between the PC and a LAN port on the router. Alternatively, the PC can be connected to the router by Wi-Fi - however file access may be slower in this case.
Figure 1. Location of DHCP setting on Controller
Steps to Access the Recordings
Navigate to Settings --> Network on the Controller
Under 'Devices' find the IP address of the 4K UHD Camera you wish to get files from
3. Enter the camera's IP address into your computer’s web browser and append ":8080" to the end.
Example: http://10.77.0.5:8080
IMPORTANT: DO NOT FORGET THE 8080 PORT
4. Click Enter and you’ll be able to visit the camera's web page where you can download and delete files on the onboard SD card