System Overview
System Specs
Minimum Pipe Diameter
Base Configuration 340mm
Major System Components
The Images below show the system major components. These references will aid in identifying parts described in this manual. (Not all components shown are standard equipment)
Side Bodies
Drive Unit
Window
Toolless Ballast
Internal Frame/Assembly
Propellers
Tether Bracket
Bulkhead Connection Overview
Below is a visual guide depicting the typical bulkhead connection points for the devices that are used in conjunction with the Deep Trekker™ DTG3. Refer to this guide if you are ever in doubt of which bulkhead to connect a specific device to. Only the tether port and battery charge ports will need to be connected/disconnected during normal use of the ROV. Thrusters, cameras, sensors, and sonar connections should never be disconnected from the bulkheads unless it is necessary for service or replacement of parts. Always ensure your bulkhead connections are fully engaged and tight before deploying the ROV and ensure that unused ports have port covers installed.
Ballasting System
The toolless ballast as shown below, will be located on all four corners of the DTG3. Too add or remove ballast, follow the diagram below.
